37
EN
Symptoms Reason Solution
UE rebalancing operation is not
successful.
• The automatic attempt to rebalance
the load was not successful. The cycle
has been paused to allow the load to
be manually adjusted.
The load is too small.
• Add more items to allow the washing
machine to balance the loads.
Heavy articles are mixed with lighter
items.
• Wash articles of somewhat similar
weight.
The load is out of balance.
• Manually redistribute the load if articles
have become tangled.
Control error.
• Unplug the washing machine and wait
60 seconds. Reconnect power and try
again. If the error code is not released,
call for service.
Water level is too high due to a faulty
water valve.
• Close the water taps, unplug the
washing machine, and call for service.
The water level sensor is not working
correctly.
• Close the water taps, unplug the
washing machine, and call for service.
A motor error has occurred.
• Allow the washing machine to stand
for 30 minutes and then restart the
cycle. If the error code is not released,
call for service.
Clutch error.
• Unplug the washing machine and call
for service.
Tub clean Alarm. • Run the Tub Clean programme.
Sensor for cloth-sensing is defective.
• Manually redistribute the load if articles
have become tangled.
Motor’s revolution is too low.
• Unplug the washing machine and wait
60 seconds. Reconnect power and try
again.
Contact-point of Connector is
defective.
To Next Page
Loading...
