Installation Instructions
11
I
nstallation Instructions
Step3: Connect hose to dryer.
• Connect the water supply hoses to the COLD
water tap tightly by hand and then tighten
another 2/3 turn with plier.
Make sure that there are no kinks in the hose
and that they are not crushed.
Step4 : Turn on cold water tap.
Check for leaks.
Check that the water taps are turned on.
Check for leaks around “Y” connector, tap, and
hoses.
Note
• After completing connection, if water leaks
from the hose, repeat the same steps.
To Next Page
Loading...
Need help?
General
