- 65 -
Copyright ©2014 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LGE Internal Use Only
Part 4 Trouble Shooting
6.6 Troubleshooting Outdoor Error
CH 25 (Input Voltage high/low)
25
Input Voltage high/low
Error
No.
Error Type Error Point Main Reasons
Input voltage is over limited
value of the product (173V
or less, 289V or more)
1. Input voltage abnormal (R-N)
2. Outdoor unit Inv. PCB damage (input volt-
age sensing part)
3. N phase line disconnection
■ Error Diagnosis and Countermeasure Flow Chart
Yes
Yes
Recheck power and installation condition
Yes
Are there any power wire
connections normal?
No
Yes
1. Check R/S/T/N wiring conditions
→ Rewire them if abnormality found.
Is input voltage normal?
No
Check
R~S/S~T/T~R phase voltage is 380V 10%
R~N/S~N/T~N phase voltage is 220V 10%
→ Check connection condition and wiring if power is
abnormal
Is Inv. PCB
bridge diode joining condition normal?
No
Check joining condition of Inv. PCB and bridge diode
→ joining again if abnormality found
Yes
Is DC_Link Wire connection
condition normal?
No
1.Check Inv. PCB P,N connector
connection condition
2.Check Inv. PCB P,N connector
connection condition
3. Check wire disconnection and wiring
→ Reassemble if abnormality found
Inv. PCB LED display error
No
Replace Inv. PCB
To Next Page
Loading...
