8
Control Panel Functions
Use this button to turn the display on or off.
The power indicator stays blue if the display is running
properly (On mode). If the display is in power saving
mode, the power indicator is flickering blue.
Power Button/
Power Indicator
Use this button to enter a selection in the On Screen
Display.
AUTO/SET
Button
AUTO IMAGE ADJUSTMENT
When adjusting your display settings, always press
the AUTO/SET button before entering the On Screen
Display(OSD). This will automatically adjust your
display image to the ideal settings for the current
screen resolution size (display mode).
The best display mode is
1680 x 1050
Buttons
Use these buttons to select or adjust functions in the On
Screen Display.
For more information,
refer to page 16.
Use this button to make either D-Sub or DVI connector
active. This feature is used when two computers are
connected to the display. The default setting is D-Sub.
(SOURCE Hot key)
To Next Page
Loading...
Need help?
General
