LG WD-1020W - Page 31

(PULLEY)
(DAMPER)
@ The back cover is removed.
@ The belt is pulled off while tuming over the
pulley.
@® The bolt is unscrewed to the shaft and then
the pulley pulled off.
@ Two screws are unscrewed from the bracket(Motor).
@ The motor is pushed to arrow direction and then
it is disassembled.
(When mounting the rubber should be fit the
bracket holder<motor>)
@ Lay the washing machine.
@ Six screws are unscrewed.
@ The hinge(Damper) at the tub is pulled off
pressing on the snaps at the sharp end.
@ The hinge at the base is pulled off.