LG WD-1020W - Page 32

INLET HOSE @ The cover(Silent) is removed .
@ The pump terminals are disconnected, the hose is
pulled off.
@ The pump bracket hook is disassembled to arrow
direction.
BRACKET, PUMP
@ Three screws are unscrewed.
@ The heater M6 bolt is loosened and it is
released through the tub cover.
When mounting the heater, the heater should be
inserted the heater clip on the bottom of the tub.
@ Pull it out by holding the thermistor bracket.
x The thermistor should be checked it is pulled
to the rubber tightly.
32
* If holding the wire and pulling out it, it may be broken.