EasyManua.ls Logo

LG WD-10580BD - User Manual

LG WD-10580BD
48 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
P / No. : MFL31245112

Table of Contents

Questions and Answers

  • K
    kristinowensSep 23, 2025
    How to fix rattling or vibrating noise in LG WD-10580BD Washer?
    • J
      Jonathan LynnSep 23, 2025
      If your LG washer is making rattling, clanking, thumping, or vibrating noises, immediately stop the washer and inspect the drum and drain filter. If the noise persists after restarting, it's recommended to call for service. If the sound continues, the washer might be unbalanced. In that case, stop the machine, redistribute the wash load, and adjust the leveling feet to ensure all four feet firmly contact the floor during the spin cycle.
  • D
    Dwayne MckinneyAug 25, 2025
    What does 'Water Inlet Error' mean on my LG Washer by LG?
    • M
      martinezmatthewAug 25, 2025
      A 'Water Inlet Error' on your LG Washer means the correct water level was not reached within 8 minutes after water was supplied, or it did not reach the preset water level within 25 minutes.
  • T
    tommyholderAug 25, 2025
    What does LOCKED MOTOR ERROR mean on my LG WD-10580BD?
    • E
      Eric NguyenAug 26, 2025
      A LOCKED MOTOR ERROR can occur for several reasons: the connector (3-pin, male, white) in the MOTOR HARNESS is not connected to the connector (3-pin, female, white) of STATOR ASSEMBLY; the electric contact between the connectors (3-pin, male, white) in the MOTOR HARNESS and 4-pin, female, white connector in the MAIN PWB ASSEMBLY is bad or unstable; the MOTOR HARNESS between the STATOR ASSEMBLY and MAIN PWB ASSEMBLY is cut (open circuited); or the hall sensor is out of order/defective.
  • D
    Dennis KimAug 27, 2025
    Why won't my LG WD-10580BD Washer start or spin?
    • E
      evansvanessaAug 27, 2025
      If your LG Washer isn't starting or spinning, ensure the plug is securely in the wall outlet. Check the circuit breaker or fuse, replacing if necessary, but do not increase the fuse capacity. If a circuit overload is the issue, consult a qualified electrician. Also, make sure the water supply tap is on, the door is fully closed, and you've pressed the Start/Pause button. Remember that it may take a moment for the washer to begin spinning after pressing Start/Pause, as the door must lock first.
  • R
    Rachel AllenSep 23, 2025
    Why is the wash cycle time delayed on my LG WD-10580BD Washer?
    • J
      John ReynoldsSep 23, 2025
      If your LG washer's wash cycle time is delayed, it could be due to an imbalance being detected or the suds removing program operating, both of which will increase the wash time.
  • R
    Rebecca JohnsonSep 13, 2025
    Why does my LG WD-10580BD have an IMBALANCE ERROR?
    • M
      Michele LewisSep 13, 2025
      An IMBALANCE ERROR can occur in your LG Washer for several reasons: the load might be too small, the appliance could be tilted, the laundry may be bunched to one side, or non-distributable items were added to the drum.
  • J
    Jose MatthewsSep 12, 2025
    What does 'EEPROM Error' mean on my LG Washer?
    • P
      Pamela MaySep 12, 2025
      An 'EEPROM Error' on your LG Washer means the EEPROM is out of order. This error is only displayed when the START/PAUSE button is first pressed in the Load Test Mode.
  • B
    Brian LarsonSep 12, 2025
    Why does my LG WD-10580BD show a 'Power Failure' error?
    • J
      Jacob SilvaSep 12, 2025
      A 'Power Failure' on your LG Washer may occur if the power supply is stopped while the washing machine is working, and then power is supplied rapidly.
  • E
    elizabeth90Sep 4, 2025
    What to do if my LG WD-10580BD overfills with water?
    • M
      marshallmichaelSep 4, 2025
      If the water overfills in your LG washer due to a faulty water valve, close the water tap, unplug the power plug, and call for service.
  • P
    paynemarySep 2, 2025
    What does 'Over Flow Error' mean on my LG WD-10580BD Washer?
    • K
      Keith RushSep 2, 2025
      An 'Over Flow Error' on your LG Washer indicates that the water is overflowing, meaning the water level frequency is over 213. If this error is displayed, the drain pump will automatically activate to drain the water.

LG WD-10580BD Specifications

General IconGeneral
Loading typeFront loading
ColorWhite
Delay StartYes
Child LockYes
Noise Level (Wash/Spin)72 dB
Dimensions (HxWxD)850 x 600 x 550 mm

Related product manuals