22
ow to use the washer
H
1. Special function display
2. Self diagnose display
3. Completion of washing
4. Time left
• If the washer encounters a fault during
operation, the associated fault will be
displayed.
“ ” : Water pressure sensing error
“ ” : Problem of overfilling water
“ ” : Door is not closed
“ ” : Over load in motor
“ ” : Over load in motor
“ ” : Water inlet trouble
“ ” : Drainage trouble
“ ” : Unbalanced load
“ ” : Water temperature trouble
If these error letters are displayed, please refer to
the troubleshooting page27 and follow the guide.
• When Child lock is selected, the
“ ” lamp is on.
• When time delay is selected, it shows the
remaining times to finish the selected program.
• When washing cycle is completed,
“ ” is displayed on the “Multi
display”.
• During washing cycle, the remaining
washing time is displayed.
• Recommended program by
manufacturer.
- Cotton : around 2 hours 2 minutes
- Synthetic :
around 1 hour 28 minutes
- Delicate : around 1 hour 16 minutes
- Wool/Silk : around 1 hour 4 minutes
- Hand Wash :
around 1 hour 4 minutes
- Duvet : around 1 hour 16 minutes
- Quick 30 : around 30 minutes
- Refresh : around 20 minutes
- Baby Care :
around 2 hours 48 minutes
• The washing time may vary by the
amount of laundry, water pressure,
water temperature and other
washing conditions.
• If an unbalanced load is detected or
if the suds removing program
operates, the wash time may be
extended.
(Max. increasing time is 45 minutes.)
Display
■ Est. Time Remaining
■ Status Indicator
• This display shows the estimated time remaining
in the cycle when operating.
• This washer automatically detects the wash load
(weight) and optimizes the washing time. After
detecting, the display will show the adjusted time
remaining.
• It shows elapsed time of the cycle the washer is
operating.
To Next Page
Loading...
