SPIN TROUBLE
Check the sensor (Pressure) or
hose (Sensor). If the problem
is on the sensor or the hose,
replace the sensor or the hose.
Normal
Correct the connector.
Correct the connector.
Replace the STATOR
ASSEMBLY
(4417FA1994E)
Check on the spinning, is the frequency of the
water level 248 or more. The frequency can be
checked by pressing the Opt.2 and Time Delay
buttons at the same time on the program.
When pressing Opt.2, Spin and POWER buttons at
the same time after power off, press the Start/Pause
button 2 times, is the drum low speed spin?
Is it disconnected, or disassembled?
[White : 3pin(
), Red:3pin( ), Red:3pin( ),
National:6pin(
)]
Is it disconnected, or disassembled?
[White:3pin (
), National:4pin ( )]
Check the motor connector, Is the resistance of
the terminal same as the figure?
MOTOR TERMINAL (1)
Resistance of terminal:
About 5 10
Replace the MAIN PWB ASSEMBLY
To Next Page
Loading...
