LG WD-14311(6)RD - Pump, Heater, and Thermistor Component Removal

34
 Remove the back cover.
 After loosening the bolt, Rotor, pull out the
rotor.
 Remove the 6 bolt from the stator.
 Disconnect the 2 connectors.
 Remove the hinges (Damper) at the Tub.
 The Hinge(Damper) at the base is pulled off
pressing on the snaps at the sharp end.
 The hinge at the base is pulled off.
(To arrow direction)
ROTOR ASSEMBLY, STATOR ASSEMBLY, FRICTION DAMPER
Rotor
Bolt
Friction
Damper
Hinge
(Damper)



HOW TO ASSEMBLE THE MOTOR