Why does my LG WD-14120(5)FD Washer show an imbalance error?
An imbalance error on your LG Washer can occur for several reasons: the load is too small, the appliance isn't level, laundry is bunched to one side, or non-distributable items are in the drum. Check these potential causes to resolve the issue.
What causes a drain error on an LG Washer?
A drain error on your LG washer means that water hasn't drained sufficiently within 10 minutes. Check the drain hose for any clogs or kinks that may be preventing proper drainage.
What causes a lock error on my LG WD-14120(5)FD Washer?
A lock error on your LG Washer can stem from several connection issues or a defective hall sensor. Here are potential causes and solutions: 1. The LEAD WIRE ASSEMBLY connector isn't connected to the STATOR ASSEMBLY connector: Reconnect or repair the connector. 2. Poor electrical contact between connectors in the LEAD WIRE ASSEMBLY and MAIN PWB ASSEMBLY: Reconnect or repair the contact in the connector. 3. The LEAD WIRE ASSEMBLY is cut: Repair the damaged LEAD WIRE ASSEMBLY. 4. The hall sensor is defective: Replace the STATOR ASSEMBLY.
What to do if my LG WD-14120(5)FD Washer shows a door open error?
A 'door open error' on your LG washer indicates that the Start/Pause button was pressed while the door was open or that the door switch is malfunctioning. Ensure the door is properly closed before starting the cycle. If the issue persists, the door switch may be faulty.
Why is my LG WD-14120(5)FD showing an overflow error?
An overflow error on your LG washer occurs when too much water enters the tub, triggering an automatic pump-out. This indicates an issue with the water level control.
What does a current error mean on my LG WD-14120(5)FD Washer?
A current error on your LG Washer can be due to two reasons. It could be a faulty MAIN PWB ASSEMBLY, in which case you should replace it. Alternatively, the winding in the STATOR ASSEMBLY might be short-circuited, requiring replacement of the STATOR ASSEMBLY.
What does a heating error mean on my LG Washer?
A heating error on your LG washer indicates that the THERMISTOR is out of order. This component is responsible for monitoring and regulating the water temperature during the wash cycle.
What does sensor pressure S/W error mean on LG Washer?
A 'sensor pressure S/W error' on your LG washer indicates that the sensor pressure switch is malfunctioning. This switch is responsible for monitoring the water pressure inside the washer.
General| Load Type | Front Load |
|---|---|
| Spin Speed | 1400 RPM |
| Energy Rating | A+++ |
| Weight | 72 kg |
| Inverter Motor | Yes |
| Steam Function | Yes |
| Smart Diagnosis | Yes |
| Programs | Cotton, Easy Care, Mix, Rinse+, Spin, Wool |
| Type | Front Load Washer |
| Dimensions (HxWxD) | 850 x 600 x 590 mm |
To Next Page
