LG WD-21600 - User Manual

Questions and Answers

K
Kim RiveraAug 11, 2025
What to do if water does not enter my LG Washer?
- F
  friedmansamanthaAug 12, 2025
  If water isn't entering your LG Washer or is entering slowly, start by checking the hose connections at the tap and washer and tighten them if they are loose. Ensure the water supply tap is fully open. Straighten any kinks in the water inlet hoses. If the issue persists, your house drain pipes may be clogged, so try to unclog them or contact a plumber. Also, check the filter of the inlet hose(s). Inadequate water supply in your area could also be the reason; check another tap in the house to confirm.
J
Joseph NelsonAug 19, 2025
How to fix LG WD-21600 that does not drain properly?
- L
  Lori JonesAug 19, 2025
  If the water in your LG Washer is not draining or is draining slowly, the drain hose might be kinked or clogged. Clean and straighten the drain hose. Also, the drain filter could be clogged, so clean the drain filter.
P
Peter BriggsAug 26, 2025
Why is my LG WD-21600 making rattling and clanking noises?
- J
  Jennifer WatsonAug 26, 2025
  If your LG Washer is making rattling, clanking, thumping, or vibrating noises, it could be due to several reasons. First, check the drum and drain filter for any foreign objects like coins or safety pins and remove them. Heavy wash loads can also cause thumping sounds, which are usually normal. If the noise persists after restarting, it may be out of balance; stop the washer and redistribute the load. Also ensure that transit bolts were removed during installation. If the load is unevenly distributed, stop the washer and rearrange it.
D
David GordonSep 3, 2025
Why is my LG WD-21600 making a rattling noise?
- L
  Linda HansenSep 3, 2025
  Your LG Washer may be making a rattling noise due to foreign objects like coins or safety pins in the drum or pump. Stop the washer and check the drum and drain filter. If the noise continues after restarting, contact an authorized service center. Heavy wash loads can also produce a thumping sound, which is usually normal. Ensure all transit bolts and packing have been removed as per the installation guide. Also, make sure all the feet are resting firmly on the ground. An unevenly distributed wash load can also cause noise; stop the washer and rearrange the load.