42
Symptoms Reason Solution
Door is not closed properly.
•
Close the door completely.
If ‘
,
, ’ is not released, call for
service.
Thermistor control error.
•
Unplug the power plug and call for
service.
Water overlls due to a
malfunction or excessively high
water pressures.
•
Close the water tap.
•
Unplug the power plug.
•
Call for service.
Malfunction of water level sensor.
•
Close the water tap.
•
Unplug the power plug.
•
Call for service.
Over load in motor.
•
Allow the washing machine to stand for
30 minutes to allow the motor to cool,
then restart the cycle.
Water leaks.
•
Call for service.
The washer experienced a power
failure.
•
Restart the cycle.
Does not dry (only on combo
dryer models)
•
Call for service.
Is Inlet/outlet hose or drainage
pump frozen?
•
Supply warm water into the tub and
unfreeze outlet hose and drainage pump.
Wet a towel in warm water and apply to
inlet hose.
Do you have problems with
washing or drying your laundry?
•
When the detergent dispenser lid is
open, the washing or drying function is
disabled. Ensure the detergent dispenser
is properly closed.
To Next Page
Loading...
