27
ow to use washer
H
• If the washer encounters a fault during
operation, the associated fault will be
displayed.
“ ” : Water pressure sensing error
“ ” : Problem of overfilling water
“ ”, “ ” : Door is not closed
“ ” : Over load in motor
“ ” : Water inlet trouble
“ ” : Drainage trouble
“ ” : Unbalanced load
“ ” : Water temperature trouble
“ ” : Dry heater or thermostat trouble.
If these error letters are displayed, please refer to
the troubleshooting page35 and follow the guide.
• When time delay is selected, it shows the
remaining times to finish the selected
program.
• When washing cycle is completed, “ ”
is displayed on the “Multi display”.
• During washing cycle, the remaining washing
time is displayed.
• Recommended program by manufacturer.
- Cotton : around 2 hours and 16 minutes
- Sports Wear :
around 1 hour and 14 minutes
- Dark Wash : around 1 hour and 12 minutes
- Cold Wash : around 1 hour and 37 minutes
- Wool : around 51 minutes
- Duvet : around 1 hour and 32 minutes
- Rinse+Spin : around 19 minutes
- Refresh : around 25 minutes
- Allergy Care :
around 1 hour and 41 minutes
- Speed Wash : around 49 minutes
- Sanitary : around 1 hour and 58 minutes
- Heavy Duty :
around 1 hour and 58 minutes
• The washing time may vary by the amount
of laundry, water pressure, water
temperature and other washing conditions.
• If an unbalanced load is detected or if the
suds removing program operates, the wash
time may be extended.
(Max. increasing time is 45 minutes.)
Display
1. Special function display
3. Completion of washing
4. Time left
2. Self diagnose display
To Next Page
Loading...
