Caution
8
1
Attach the water supply hose to the tap.
Screw Type
Push the water supply hose up so that the rubber
packing within the hose can adhere completely to
the tap.
2
Connect the water supply hose to the tap.
Connect the water supply hose to the tap and then tighten
it by screwing it to the right.
3
Check water leakage.
Connecting Water Supply Hose to the machine
After connecting the hose, open the tap to
check for any water leakage.
• Connect the water supply hose to intel valve
of the washing machine, and then lock it by
turning the hose connecting part.
• Check to see if there is a rubber seal inside
the connector.
For the cold water (1valve) model, Do not connect to the hot water supply.
It will damage your clothes.
To Next Page
Loading...
