martDiagnosis
TM
S
37
Troubleshooting
Close the washer door, and press the
POWER (AUTO OFF)
button.
Place the phone to SMARTDIAGNOSIS
TM
display.
Hold the phone while data is transmitted.
Long press
WATER TEMP. button to activate smart diagnosis.
After the data transmission is completed, listen to the diagnosis result from the consultant.
1
3
4
5
2
•
If you manipulated other button or dial before
pressing WATER TEMP. button, turn off the
power and start again from the beginning.
•
Make sure that the
speaking side of the
phone to face
SMARTDIAGNOSIS
TM
display
•
Place the phone near the
SMARTDIAGNOSIS
TM
display, and long press
WATER TEMP. button
until tak tatk tak sounds.
•
Keep placing phone to SMARTDIAGNOSIS
TM
display while data for smart diagnosis is being
transmitted. The time remaining for data
transmission will be displayed on screen.
•
Transmission sound may be irritating. For
proper diagnosis, do not take off the phone.
You can press power button to stop diagnosis
function and the sound.
•
When data transmission is completed, the
power is automatically turned off with End
display after a few seconds.
NOTE
Smart Diagnosis is a troubleshooting feature designed to assist, not replace, the traditional method of
troubleshooting through service calls. The effectiveness of this feature depends upon various factors,
including, but not limited to, the reception of the cellular phone being used for transmission, any
external noise that may be present during the transmission, and the acoustics of the room where the
machine is located. Accordingly, LG does not guarantee that Smart Diagnosis would accurately
troubleshoot any given issue.
To Next Page
Loading...
Need help?
General
