What to do if water inlet filters are clogged in LG WKGX201HRA Laundry Appliance?
Clean the inlet filters of your LG Laundry Appliance. Refer to the MAINTENANCE section for detailed instructions.
Why does my LG Laundry Appliance beep when pressing a button and then nothing happens?
If your LG Laundry Appliance beeps when you press a button but nothing happens, it's likely that the Control Lock feature is activated. To deactivate it, turn on the washer and then press and hold the button labeled 'Control Lock' (or the button located directly under it) for about 3 seconds.
Why is there so little water in my LG Laundry Appliance?
HE (High-Efficiency) LG Laundry Appliances are designed to properly wash your laundry while using a minimum amount of water and energy.
What to do if water supply pressure is too low in LG Laundry Appliance?
Check another faucet in the house to make sure that household water pressure is adequate and flow is not restricted. Disconnect the water inlet hoses from the washer and run a few gallons of water through the hoses to flush out any dirt. If flow is too low, contact a plumber to have the water supply lines repaired.
Why is there little water in my LG WKGX201HRA Laundry Appliance?
HE (High-Efficiency) LG Laundry Appliance washers are designed to wash clothes properly using a minimal amount of water and energy.
What to do if water inlet hoses are kinked in LG WKGX201HRA Laundry Appliance?
Make sure the water inlet hoses behind or under your LG Laundry Appliance are not kinked, pinched, or crushed. Take care when moving the washer for cleaning or maintenance to avoid damaging the hoses.
What does it mean when the Flow Sense indicator shows four bars or the display shows d8O on my LG Washer/Dryer?
What does it mean when the Flow Sense indicator shows four bars or the display shows d8O on my LG Washer/Dryer? This can be due to an exhaust system that is too long or has too many turns, or a partial blockage in the ductwork. Install a shorter or straighter duct run and ensure the ductwork is checked and cleaned immediately.
How to turn off the Control Lock on my LG Washer/Dryer?
How to turn off the Control Lock on my LG Washer/Dryer? To disable Control Lock, turn the dryer on, then press and hold the button designated for Control Lock for 3 seconds.
What to do if the water supply pressure is too low in my LG Laundry Appliance?
Check another faucet in the house to ensure adequate household water pressure and unrestricted flow. If the pressure is low, disconnect the water inlet hoses from the washer and flush out any dirt by running a few gallons of water through them. If the flow remains too low, contact a plumber to repair the water supply lines.
How to stop my LG WKGX201HRA from making loud banging noises while filling with water?
If your LG Laundry Appliance is making loud banging noises while filling with water, the issue probably lies within your home's plumbing. A recommended solution is to install a device known as a water hammer arrestor.
General| Brand | LG |
|---|---|
| Model | WKGX201HRA |
| Category | Laundry Appliance |
| Language | English |
To Next Page