J
jennifer86Sep 5, 2025
What to do if my LG Washer experienced a power failure?
- SsamanthafrederickSep 5, 2025
If your LG washer experienced a power failure, restart the cycle.
To Next PageTo Next PageWhat to do if my LG Washer experienced a power failure?
If your LG washer experienced a power failure, restart the cycle.
What does 'Water Inlet Error' mean on my LG WM2016CW Washer by LG?
A 'Water Inlet Error' on your LG Washer means the correct water level was not reached within 8 minutes after water was supplied, or it did not reach the preset water level within 25 minutes.
What does LOCKED MOTOR ERROR mean on my LG WM2016CW Washer?
A LOCKED MOTOR ERROR can occur for several reasons: the connector (3-pin, male, white) in the MOTOR HARNESS is not connected to the connector (3-pin, female, white) of STATOR ASSEMBLY; the electric contact between the connectors (3-pin, male, white) in the MOTOR HARNESS and 4-pin, female, white connector in the MAIN PWB ASSEMBLY is bad or unstable; the MOTOR HARNESS between the STATOR ASSEMBLY and MAIN PWB ASSEMBLY is cut (open circuited); or the hall sensor is out of order/defective.
Why won't my LG Washer start or spin?
If your LG Washer isn't starting or spinning, ensure the plug is securely in the wall outlet. Check the circuit breaker or fuse, replacing if necessary, but do not increase the fuse capacity. If a circuit overload is the issue, consult a qualified electrician. Also, make sure the water supply tap is on, the door is fully closed, and you've pressed the Start/Pause button. Remember that it may take a moment for the washer to begin spinning after pressing Start/Pause, as the door must lock first.
What to do if my LG Washer has water leaks or excessive suds?
If you notice water leaks or excessive suds in your LG washer, check and tighten all hose connections first. If the issue persists, unclog the drain pipe, contacting a plumber if necessary. To address excessive suds, reduce the amount of detergent you're using or switch to an HE (High Efficiency) detergent.
Why is water not entering or draining properly in my LG Washer?
If water isn't entering your LG washer or is draining slowly, start by checking another tap in your house to ensure adequate water supply. Fully open the tap connected to the washer. Straighten any kinks in the hose. Inspect the filter of the inlet hose for clogs. Additionally, clean and straighten the drain hose, and clean the drain filter to ensure proper drainage.
What does 'EEPROM Error' mean on my LG Washer?
An 'EEPROM Error' on your LG Washer means the EEPROM is out of order. This error is only displayed when the START/PAUSE button is first pressed in the Load Test Mode.
What to do if I get a 'Door Open Error' on my LG WM2016CW?
If you're getting a 'Door Open Error' on your LG Washer, it could be due to a few reasons. First, make sure the door is completely closed. If it is, check for loose electrical connections at the door switch and PWB assembly. If those seem fine, the door switch assembly itself might be faulty and out of order.
What to do if my LG WM2016CW overfills with water?
If the water overfills in your LG washer due to a faulty water valve, close the water tap, unplug the power plug, and call for service.
What does 'Over Flow Error' mean on my LG WM2016CW Washer?
An 'Over Flow Error' on your LG Washer indicates that the water is overflowing, meaning the water level frequency is over 213. If this error is displayed, the drain pump will automatically activate to drain the water.
General| Type | Front Load Washer |
|---|---|
| Width | 27 inches |
| Steam Washer | No |
| Color | White |
| Energy Star Certified | Yes |
| Delay Start | Yes |
| Child Lock | Yes |
| Wi-Fi Enabled | No |
| Depth | 29.75 inches |
| Height | 38.75 inches |