SPIN TROUBLE
Check the SENSOR SWITCH
ASSEMB
LY or HOSE (Pressure).
If the problem is on the
SENSOR
SWITCH ASSEMB
LY or the
HOSE, replace the SENSOR
SWITCH ASSEMB
LY or the
HOSE.
Normal
Correct the connection.
Replace the STATOR
ASSEMB
LY
Check during spin if the frequency of the water
level is 248 or more.
Press the
START/PAUSE button 2 times in QC
Test mode, is the drum spinning at low speed?
Is it disconnected, or disassembled?
[Red: 3pin (1), NA: 4pin (2)]
Check the motor connecto
r, Is the resistance of
the terminal the same as the figure?
MO
TOR TERMINAL
Resistance of terminal:
①-②/②-③/③-①: About 5 Ω- 15 Ω
Replace the MAIN PWB ASSEMB
LY
Does the spring of Latch Hook actuate?
Is there clicking sound once or twice when the
START/PAUSE button is pressed to start the cycle?
Is DOOR SWITCH ASSEMBLY broken?
Replace Door Assembl
y.
Check the DOOR SWITCH
ASSEMB
LY Connector and
MAIN PWB ASSEMB
LY
(Red 3 pin,
Yellow 4 pin and
white 3 pin connector (1)).
Replace the DOOR
SWITCH ASSEMB
LY.
③ ② ①
To Next Page
Loading...
