23
WM2688H*M Steam Washer Training
Accessories
The washer comes with the two input hoses. The blue stripe is for cold
water and the red stripe is for hot water. While the hoses are mechanically
identical, it is critical to the performance of the washer to have the hot and
cold hoses connected correctly.
The wrench is used to remove (and replace) the shipping bolts and to
adjust the leveling feet. Be sure to leave it and encourage the customer to
retain the wrench, the four shipping bolts, and the manual in a safe place
in the event the washer requires service or the customer moves.
The shipping bolts MUST BE REMOVED before operating the washer.
T- 13
To Next Page
Loading...
