4-4-SPECIFICATION
so_tio_
Wrinkling i° Did you remove the load immediately after • Remove the load immediately after it
i i it finished? i finishes.
i i° Did you overload the tub? i _ Do not overload the tub.
i _ Did you reverse the hot and cold water • Hot water rinse call cause garments to
i i inlets? i wrinkle. Check the inlet hose connections.
Power is not turned on • Is the power cord plugged in properly? j. Make sure that the plug is secured ina
Has a house fuse blown, a circuit breaker grounded 3-prong, 120 V (60 Hz) outlet.
tripped, or a power outage occurred? J. Reset the circuit breaker or replace the
i + +
The door does not open i" Is the temperature in the tub too high?
Jwhenthecyclepausesorfinishes • Is the water level in washer high?
Allow the washer to complete the
programmed cycle, or Press the Spin
button.
[Thewash cycietime is i; is{hewashing machineoverioaded?Are [; q-hisis normail q-hewashing machine
i longer than usual i other options added to the wash cycle? automatically adjusts the cycle time for
i the amount of laundry, water pressure,
i water temperature, and other operating
i i conditions.
iltismusty°rm°ldyinthe i" Has the incorrect detergent been used? i • See page 37, clean the inside and outside
tub i. Did you clean the tub periodically? of the washing machine periodically.
i
fuse. Do not increase the fuse capacity. If
the problem is a circuit overload, have it
corrected by a qualified electrician.
The washing machine has a safety lock
built into the door to prevent burning.
Leave the door closed and wait until the
door lock icon disappears from the display.
SPECIFICATIONS
Model WM3570H*A
' T
Description iFront Loading Washer
Electrical requirements i120 VAC @ 60 Hz
, f
Dimensions i68.6 cm (W) X 75.6 cm (D) X 98.3 cm (H), 129.5 cm (D with door open)
i27" (W) X 293/4" (D) X 3811/16" (H), 51" (D with door open)
' t
Net weight i92kg(202.81bs)
Max. spin speed 1300 RPM
Max. water pressure il 4.5 - 142 PSI (100 - 980 kpa)
To Next Page
Loading...
