LG WM3600HVA - User Manual

Questions and Answers

S
Sandra WhitneyAug 10, 2025
What to do if my LG WM3600HVA Washer shows IE INLET ERROR?
- S
  Samantha HendersonAug 10, 2025
  The IE INLET ERROR on your LG Washer indicates a water supply issue. Here's what to check: 1. Ensure the water supply faucets are fully open. 2. Inspect the water inlet hoses for any kinks, pinches, or crushing, especially behind or under the washer. 3. Clean the water inlet filters, as they may be clogged. 4. Verify that the water supply pressure to the faucet or house is adequate by checking another faucet. 5. Avoid using leak-limiting hoses for the water supply connection.
B
beasleyjacobAug 15, 2025
What to do if my LG WM3600HVA shows an IE Inlet Error?
- M
  Monica HernandezAug 15, 2025
  If your LG Washer displays an IE Inlet Error, it could be due to several reasons: * Ensure the water supply faucets are fully open. * Check that the water inlet hoses are not kinked, pinched, or crushed behind or under the washer. Take care when moving the washer. * Clean the inlet filters, referring to the MAINTENANCE section for instructions. * Verify that household water pressure is adequate by checking another faucet in the house. Disconnect the water inlet hoses from the washer and run a few gallons of water through the hoses to flush out any dirt. If the flow is too low, contact a plumber to repair the water supply lines. * Avoid using leak-limiting hoses, as they can falsely trip and prevent the washer from filling.
G
George SloanAug 20, 2025
How to stop loud banging noises from LG Washer when filling with water?
- J
  Jennifer BallardAug 20, 2025
  The loud banging noises your LG Washer makes while filling with water are likely due to a plumbing issue in your home, known as water hammer. To mitigate this, consider installing a water hammer arrestor.
R
Richard ColemanAug 25, 2025
How to deactivate control lock on LG WM3600HVA?
- M
  moorejacobAug 26, 2025
  If your LG Washer beeps when you press a button but nothing happens, the Control Lock feature may be activated. To turn it off, turn on the washer, then press and hold the button that has Control Lock on or under it for 3 seconds.
W
whitney37Aug 30, 2025
Why does my LG WM3600HVA beep and then nothing happens?
- C
  Christopher DuncanAug 31, 2025
  If your LG Washer beeps and does nothing when you press a button, it's likely that the Control Lock feature is activated. To deactivate it, power on the washer, then press and hold the button labeled with 'Control Lock' (or the button directly beneath it) for approximately 3 seconds.
N
natasha69Sep 4, 2025
Why is my LG WM3600HVA making loud banging noises when filling with water?
- P
  Philip MurphySep 4, 2025
  The loud banging noises your LG Washer makes while filling with water are likely due to a plumbing issue in your home, known as water hammer. You can reduce this effect by installing a water hammer arrestor, which can be purchased at your local hardware or home improvement store.

LG WM3600HVA Specifications

General

Appliance Category	Washer
Type	Front Load
Capacity	4.5 cu. ft.
Steam Technology	Yes
Smart Technology	Yes
Energy Star Certified	Yes
Spin Speed	1300 RPM
Wi-Fi Connectivity	Yes
Width	27 inches
Depth	30.25 inches
Height	39 inches