The dampers (3) support the tub at the
bottom; it is supported by two springs
at the top and by the gasket on the front.
Use special tool 383EER4003A.
1. Remove the damper hinge
pins. (A special tool is available
for this. Using a 5/8 deep well
socket makes this easier by
holding down the locking tab so
the pin slides out easily. )
2. Replace the damper with a new
part. Do not reuse a damper
that has been disassembled.
p44
Repair – Motor
WM3677HW
To Next Page
Loading...
