31
Installation
C
onnecting Water Supply Hose
Attach the water supply hose to the tap.
Push the water supply hose up so that the rubber
packing within the hose can adhere completely to
the tap.
Connect the water supply hose to the tap.
Connect the water supply hose to the tap and then
tighten it by screwing it to the right.
Check water leakage.
After connecting the hose at both ends, open the
tap to check for any water leakage.
• Connect the water supply hose to the correct
temperature inlet valve by screwing it onto the
thread clockwise. Ensure that the tread is not
crossed or over tightened with any mechanical
device. All inlet hoses should be firmly
tightened by hand
• Check to see if there is a rubber seal inside the
connector prior to making connection.
Screw Type
Water Supply Hose
Rubber Packing
Hose connector
Rubber seal
Water
tap
Connecting Water Supply Hose to the machine
1
2
3
To Next Page
Loading...
