. Using the Download jig
Service Bulletin
WASHING MACHINE
STEP2 : Make sure the washer power cord is unplugged before updating S/W
※CAUTION : IF YOU DON'T UNPLUG THE WASHER POWER CORD WHEN YOU UPDATE S/W,
IT WILL CAUSE FATAL DAMAGE TO PCB JIG.
STEP3 : Connect the power adapter to PCB jig (1,2,3)
▶ After Step2, this should be displayed on the screen
1
2
3
[PCB Jig]
Confirm S / N
1. Front
2. PCB jig connector
3. AC adapter
Back
Dip Switch
Turn on 1, 4
This is direct mode.
To jig
STEP 1 : Copy files to PCB jig.
You must copy the files (0000d93f.t45, 00005144.t45)to the PCB jig.
→ S/W files were already copied to the micro SD in PCB JIG
※ When you update other programs for other models, file copy is also needed.
Failure to do this will cause the download to fail.
To PCB
To jig
To PCB
Main
Display
1 4
3 / 9
To Next Page
Loading...
