Service Bulletin
WASHING MACHINE
STEP6 : Updating S/W
Tmp45 Mode
0000d93f.t45
▶ This Message , Direct Mode can not Check PCB,
that download,
After you check this, push the button.
▶ Push the button until the displayed program
file name is the one you intend to use. You must
verify the model number and select the correct
program software for that model in the service
bulletin for each model. Scroll the Push button on
the jig to locate the correct software.
Try connect 1
Status check
Progress
5 Percent
Success
d93f
▶ After finishing, the program file name will be
displayed
This name must to be the same as check-sum.
Erasing mode
Baudrate Setting
31250
▶ It is displayed the Program upgrade progress.
: 5 → 10 → ~ → 100 Percent
▶ Push the button one more time.
It begins to upgrade program.
This Mode can’t
Check PCB
▶ After finding the program matched to the Model,
Push the button for a Long Time (more than 3sec) ,
you will hear a beep sound and display the
“File Selected
0000d93f.t45”
File Selected
0000d93f.t45
▶ Push the button on back of jig
to change mode step by step
6 / 9
To Next Page
Loading...
