16
3-3. FUNCTION OF EACH BUTTON. (WT5101H*)
WASH / RINSE
• Select to select Water (Wash/Rinse)
Temperature.
• Pressing the button allows The selection of
COLD/COLD
▶
WARM/COLD
▶
WARM/WARM
▶
HOT/COLD
▶
EXTRA HOT/COLD
respectively. Default setting is Warm/Cold.
• The following settings are
indicated as the button is pushed
SOAK ▶ SPIN ONLY ▶
RINSE+SPIN
• Select COTTON/NORMAL,
HEAVY/DUTY or TOWLES
as the button is pushed SOAK ▶
STAIN CARE ▶ SPIN ONLY ▶
RINSE+SPIN
SPECIAL USE
SOIL LEVEL
•
Allows a selection to be make for the strength
of the wash action.
•
Power option selections light up in
sequence as follows Normal
▶
Heavy
▶
Light
▶
Normal as the button is pushed.
This can be selected for any program.
•
Adjustment can be made while washing.
•
Default SOIL LEVEL is Normal.
Note
The time shown on the display is the estimated cycle time. If the sensors and microprocessor elect to
make changes during the cycle, the display will be adjusted accordingly.
SPIN SPEED
• Spin speed can
be selected from
No Spin to Extra
high. Default is
Low.
(refer to page 24)
SOAK
• Gives additional soak time.
POWER
• Power on.
• Push again, power goes off
• Power goes off automatically after the wash is
finished.
• After turning the power on, the unit will
automatically turn off if nothing is selected.
LOAD SENSING
• It operates in all program.
• During being detected by the sensor, the LOAD SENSING
LED flashes.
• It automatically sensing the quantity of laundries.
• During this step, the washing machine select optimized
washing algorithm.
To Next Page
Loading...
