LH 1000 - Table of Contents

LH 1000 O
PERATORS
& F
ITTING MANUAL
C
ONTENTS
LH A
GRO 3
Contents
INTRODUCTION .................................................................................................................4
GENERAL OVERVIEW .......................................................................................................5
THE LH 1000...............................................................................................................6
SECTION FUNCTION.................................................................................................6
ENCODING THE LH 1000 (FUNCTION SET 1) ..................................................................7
WORKING WIDTH ......................................................................................................7
FORWARD SPEED CALIBRATION (WHEEL CIRCUMFERENCE) ...........................7
WHEEL CIRCUMFERENCE WITH MAGNETS FITTED TO THE WHEEL.............7
WHEEL CIRCUMFERENCE WITH A MAGNET FITTED TO CARDAN SHAFT.....8
OPERATING THE LH 1000 .................................................................................................9
FUNCTION SET 1.......................................................................................................9
WORK TIME IN HOURS AND MINUTES ...............................................................9
AREA TRIP & TOTAL COUNTERS ........................................................................9
FORWARD SPEED ................................................................................................9
FUNCTION SET 2.....................................................................................................10
RPM ......................................................................................................................10
UNIT COUNTER ...................................................................................................10
DISTANCE COUNTER .........................................................................................10
FITTING THE LH 1000 ......................................................................................................11
FITTING THE MONITOR ..........................................................................................11
POWER SUPPLY......................................................................................................11
GENERAL WIRING...................................................................................................11
FITTING THE WHEEL SENSOR ..............................................................................12
FITTING THE AREA ON/OFF (IMPLEMENT) SENSOR...........................................14
TESTING THE SYSTEM ...................................................................................................15
ERROR WARNING............................................................................................................15
NOTES ..............................................................................................................................16