LAI-2200 Plant Canopy Analyzer
Quick Start Guide
Install Batteries Display Brightness
Console: 4 AA batteries
Wand: 2 AA batteries, unless attached to console
LAI-2200
Plant Canopy Analyzer
OK
LOG
START
STOP
MENU
EXIT
1 2 3
4 5 6
7 8 9
0. -
abc def
ghi jkl mno
pqrs tuv wxyz
X Y
1 2
Press and hold
the minus (-)
key, then...
Brighter
Dimmer
Cable Precautions
To attach: Align the red dots and press. Do not hang the instru-
ment from the cable.
Avoid sharp bends in the cable.
To release: Grasp the collar and pull.
Do not pull directly on the cable.
Do not drop onto the cable connections.
View Caps Sky Conditions
Always use the same view cap for associated
above- and below-canopy readings. Use the view-
restricting caps:
l To block the sun from the sensor's view.
l To block the operator from the sensor's view.
l When cloud cover is non-uniform.
l When there are gaps or clumps in the canopy.
l To reduce the required plot size.
l To make above-canopy measurements in a
small forest clearing.
l Optimum sky conditions are uniform overcast
or immediately before sunrise or after sunset.
l Clear, partly cloudy, or other sky conditions
are suitable with proper sampling technique.
l The worst sky conditions are under direct sun-
light. Refer to the LAI-2200 Instruction Manual
for more details.
Copyright LI-COR, Inc.
www.licor.com • 1-402-467-3576 • 2/21/2013 • 988-13397
To Next Page
Need help?
General
