Congratulations on your purchase of your new high quality security safe designed and built by
America’s #1 gun safe company—Liberty Safe! To insure proper set up and installation, PLEASE
READ THIS USE AND CARE MANUAL before opening your safe.
SAFETY PRECAUTIONS
The safe door is heavy. Do not open the door with the safe on an uneven or unstable floor.
Hanging on an open door may cause the safe to tip forward when not lag-bolted to the floor,
resulting in serious injury or death to yourself or others. If you have or have occasion to
have small children in your home, please make sure you never leave your safe unsecured. It
is possible for small children to climb inside your safe and become locked in. This could
result in serious injury or death.
PACKAGING MATERIALS
After opening the safe, remove the plastic protectors or foam in the corners of the door. The fire
seal is covered with a thin protective film. Please remove film before using the safe. (Note: Do NOT
remove any part of the black rigid fire seal)
INSPECT YOUR SAFE
Inspect your safe for shipping damage as soon as you receive it. If you find any damage, please
contact the delivery company (or carrier) immediately. Any damage not noted upon delivery must
be reported within fifteen (15) days or there will be no recourse.
SERIAL NUMBER & MASTER COMBINATION (See opening instructions before proceeding)
PLEASE NOTE: If your safe has been installed with an S&G Electronic Lock, use the
Electronic Lock Opening Instructions on page 6 before proceeding.
Your safe’s serial number is located in two (2) locations on the safe. One is located on the top of
the safe, back right side. The second is located inside the opening edge of the door. Compare the
serial number in this manual with the serial number on the safe. All serial numbers should match. If
they do not, contact your local dealer or Liberty Safe immediately. You will need your safe serial
number when contacting customer service about your safe.
PLEASE NOTE: Record your safe’s serial number and combination and store in a
secure location OTHER THAN YOUR SAFE. (For storage suggestions see lost combination sec.)
MANUAL LOCK—OPENING INSTRUCTIONS (FIRST TIME)
The combination lock on your safe has been set randomly at the factory. Most safes come
standard with a key-locking dial. To unlock the dial, insert the dial key and turn the key a half a turn
clockwise. Turn the dial to the right (clockwise). The dial should stop at about “87”. Turn safe
handle and open door. With door open, you can now verify your combination.
PLEASE NOTE: If the dial does not stop at “87” and continues to spin freely, the lock
has been activated and you will need to open the combination (see paragraph on page 5
named LOCK—OPENING INSTRUCTIONS) with the door closed.
To Next Page
Loading...
