Liberty 1 - Safe Opening and Locking Procedures; Verify Combination and Extend Bolts; Manual Lock Opening Instructions; Using the Key-Lock Feature

Owner Use and Care Manual
Rev: 5.17.12 Page 7
EXTENDING BOLTS BEFORE VERIFYING COMBINATION
It is preferred to verify your safe combination with the door open. If there are problems, it is easier
to service the lock or mechanism with the door open. Before verifying your combination, you will
need to extend the door bolts while the door is open. Keep door open. You can now verify your
combination.
VERIFYING THE COMBINATION
The combination lock on your safe has been set randomly at the factory. After completely dialing
the combination provided with your safe, turn the safe handle and open door. With the door open it
is recommended that you verify the combination opens a few times before using the safe. It is also
strongly recommended to do this after moving the safe.
LOCK—OPENING INSTRUCTIONS
The lock requires accurate alignment with the index mark (located at twelve noon on the dial ring).
Always turn the dial slowly and steadily when entering your combination to avoid dialing past your
numbers. Never spin the dial rapidly back and forth as this may cause damage to the lock. If
you go past any number – even if by only a half a number – the entire combination must be re-
dialed. To verify your combination, follow the four steps below. Copy your combination numbers
from page 1 to the spaces below.
Step 1
Turn the dial
counterclockwise
(LEFT) at least 4
times stopping on the
1
st
number at the
index mark.
1
st
#__________
Step 2
Turn the dial
clockwise (RIGHT)
passing the 2
nd
number twice. Stop on
it the 3
rd
time.
2
nd
#__________
Step 3
Turn the dial
counterclockwise
(LEFT) passing the
3
rd
number once.
Stop on it the 2
nd
time.
3
rd
#__________
Step 4
Turn the dial clockwise
(RIGHT) until the dial
stops (about 87). You
will feel some
resistance at about 95.
Keep turning until the
dial completely stops
at about 87.
Step 5 – If combination is entered correctly, you will be able to easily turn the safe handle and
open the safe.
IF COMBINATION DOES NOT WORK, DO NOT CLOSE DOOR! Try Again. Refer to the
TROUBLE SHOOTING GUIDE in the back of this manual for more help.
USING THE KEY-LOCK (DAY-LOCK) FEATURE
PLEASE NOTE: The Key-lock will lock the safe. However, to obtain the
highest level of security it is recommended to lock the safe using the combination
and key-lock together.