7 GB/IE/NI
temperature felt on the human body, which depends
on the wind speed. The wind chill is the measurement
used for wind-dependant cooling of an object.
Humans feel this wind chill particularly on the face.
As wind chill can only be calculated for temperatures
close to or under the 0 °C limit, it is mostly replaced
by the heat index for higher temperatures (Heat Index).
9. Functions
Weather station:
– Radio-controlled DCF-77 time signal reception
with time display, time-zone setting
– Date display
– Alarm clock with snooze function
– Room temperature and interior humidity display
with storage of the minimum and maximum
measurement values
– Outside temperature and outside humidity
display with storage of the minimum and
maximum measured values
– Barometric pressure display
– Weather trend display
– Battery status display (weather station, wind
gauge and rain gauge)
– Wind direction display
– Wind speed with wind alarm
– Dew point display (Dew Point)
– Ice/frost alert
– Precipitation display
– Wind speed and wind direction display
– Wind chill display (Wind Chill)
– Can be mounted standing or hanging
– For indoor use only
Wind gauge:
– Transmits the wind speed, temperature and humid-
ity to the weather station on 434 MHz frequency
– Assembled on a mast of approx. ø 25–31 mm
– Can only be assembled in areas free from
buildings, walls or other obstructions, as the
measurement values will otherwise be impaired.
Rain gauge:
– Transmits rainfall quantity to the weather station
on 434 MHz frequency
– Easy to stand or mount with screws on an even
surface
– It is best to stand or mount the rain gauge in an
areas which are not protected from rain.
CAUTION!
Comply with the following safety instruc-
tions when using the wind gauge and
rain gauge:
– Never immerse the measuring products in water
or other liquids
– Never place the measuring products in ovens
or microwaves
– Never expose the measuring products to tem-
peratures below –20 °C or above 60 °C
– Keep the measuring product away from
chemicals
10. Commissioning
WARNING!
Familiarize yourself with the weather station, wind
gauge and rain gauge before assembly. The operating
instructions are easier to understand if you are hold-
ing the products in your hand while reading them.
Setting up the weather station:
The weather station comes with a pre-assembled
stand, making it easy to set up the weather station
in the desired position.
Note: Remove the protection foil form the display
(weather station) before use.
Note: Remove all packing material before use
To Next Page
Loading...
