MO51-00K51-A015
Life Fitness Recumbent Series Exercise Bikes
How To:… INSTALL THE ACCESSORY TRAY
Tools Required: Phillips screwdriver, 5/32” Hex Key wrench
Recumbent Models Kit Required
9500HR AK51-00072-0000
9100, 5500HR, 4500 AK51-00074-0000
Step 1
Using a Hex Key wrench remove the four SCREWS (A) and WASHERS (B) securing the SEAT BACK (C). Remove
the SEAT BACK and set it aside.
Step 2
Slide the ACCESSORY TRAY (D) over the user right SEAT BACK POST (E) and down to make contact with the
SEAT HANDLEBAR (F).
Step 3
Position the UNDERSIDE CLAMP BRACKET (G) around the
SEAT HANDLEBAR (F) and tighten the two CLAMP
SCREWS and WASHERS (H).
NOTE: BE CAREFUL NOT TO OVER-TIGHTEN
THE SCREWS (H).
Step 4
Align the four holes in the SEAT BACK (B) with those in the
SEAT BACK POSTS. Insert the four SCREWS (A) and
WASHERS (B) through the backside of the SEAT BACK
POSTS (E) and into the SEAT BACK. Tighten the four
SCREWS securely.
NOTE: BE CAREFUL NOT TO OVER-TIGHTEN THE
SCREWS (A).
D
B
E
A
Need help?
General
