PREPARATION
Place the heater on a firm, level surface and plug into a grounded 120V 60Hz power outlet.Heater to be
operated only in upright position with caster wheels attached.
Turn on the main power switch in the rear of the unit.Press the On/Off button on the display to power up
the heater’s display.
You may use the ON/OFF button on the remote as well, but you will need to insert 2 AAA batteries into
the remote control battery compartment before using (Batteries Sold Separately)
℃/℉button: Button for alternating between Fahrenheit and Celsius
ON/OFF button: Powers the display on and off
Temp up button: To increase desired temperature
Temp down button: to make set temperature decline
Timer button: Used to engage timer mode and to set hour value for the timer
Mode button: Used for mode selection
Battery compartment (rear of remote)
Battery compartment cover
To Next Page
Loading...