LifeGear 75118 Inversion table - Safety Operating Instructions; Step 10: Strap and Strap Lock Assembly; Step 11: Strap Attachment to Frame

STEP 10:
Attach the Nylon Strap (32) to the Strap Lock (34) by inserting the end of the Nylon Strap (32) up
through the bottom of the Strap Lock (34), loop the Nylon Strap (32) over the Pre-assembled Loop
Strap (33) and down through the Strap Lock (34). Now, loop the strap back over itself, and insert
back through the Strap Lock (34), and pull tight to secure.
STEP 11:
Attach the Nylon and Loop Straps (32, 33) to the Inversion Table by hooking the end of the Nylon
Strap (32) to the pre-assembled loop on the back of the Bed Frame (4) as shown. Now hook the
other end of Loop Strap (33) to the other Pre-assembled loop on the Front U-Frame (1) as shown.
14
19 3433 32 19
19
33
34
32
19
34
32
1
4
19
19