4
Set up your communicator in a centrally
located place in your home. This allows the
two-way communication between you and
the operator to work most eectively.
1 Plug the power cube into an electrical
outlet that is not controlled by
a light switch.
2 Slide the ON/OFF switch on the bottom of
the communicator to the “ON” position.
The green light on the top of the device will
ash until cellular service is acquired.
3 When the system is ready, you will hear
the welcome message and voice prompts
will assist you through setup.
4 When prompted press and release your Personal HELP
Button. You will hear a tone, and the BLUE light on the
HELP bar will ash. Your system will announce, “Dialing the
Emergency Response Center now. To cancel this call, please
press the HELP Bar now”. Do not cancel the call. Wait to
speak to the Emergency Response Center.
SETTING UP YOUR SYSTEM
THE WELCOME MESSAGE WILL CONTINUE
TO PLAY UNTIL SETUP IS COMPLETE.
ON/OFF
BUTTON
To Next Page
