Wellness Recovery Collection 9 8 AllevaBody User Manual Lifepro
SETTING UP THE ALLEVABODY
• Unroll the AllevaBody Red Light Therapy Wrap and lay it (with
the neck hole facing up) on a flat, sturdy, heat-resistant surface
such as a bed, couch, or floor.
• Plug the female end of each remote control cable into the 3-pin
male connector jack in the corner of each red light mat (top
and bottom). Twist each locking ring clockwise to secure the
connectors together.
• Plug the male end of each remote control cable into the 2-pin
female connector on each power supply. Twist each locking ring
clockwise to secure the connectors together.
• Plug a power cord into each power supply.
• Plug each power cord into a standard electrical outlet.
PREPARING TO USE THE ALLEVABODY
• Before using the AllevaBody, it’s important to do a skin
sensitivity test to ensure you won’t experience any adverse
reactions to phototherapy. See TESTING FOR SKIN
SENSITIVITY on page 7.
• Place a water bottle and any desired entertainment (such as a
tablet, phone, or book) within easy reach. You may also wish to
grab a pillow for comfort.
• Remove your shoes, heavy clothing, and any metal jewelry or
accessories.
• Wear clean, comfortable, loose-fitting cotton clothing and
socks, or remove your clothing if you prefer. If you are treating a
particular area, it is best to not wear clothing in that area.
• Unzip one side of the AllevaBody.
• Climb into the AllevaBody as you would a sleeping bag and close
the zipper. Your head will be at the top, outside of the therapy
wrap.
EASYSTART SETUP GUIDE
3
2
1
Wellness Recovery Collection 9
USING THE ALLEVABODY
NOTE: Each red light mat is controlled by its own remote control.
You may use different settings for each mat if desired.
• The remote control will turn on automatically when connected
to power. The default treatment program will display on the
screen: RED&NIR mode (red light + near-infrared therapy), 100%
brightness, pulse frequency “Null” (off), for 10 minutes.
• If you wish to change the default treatment program, press the
Settings button to toggle through the time, mode, brightness
level, and frequency options. Use the
and buttons to adjust
the settings as needed. It’s a good idea to start with a lower
brightness level and pulse frequency and a shorter working time
when you are first using the AllevaBody.
• Press the On/Off button to begin the session.
• Relax and enjoy your treatment session. The device will turn off
automatically at the end of the set working time. Always unplug
the power cables after use.
• See TIPS FOR USING THE ALLEVABODY on page 10 and the
OPERATING INSTRUCTIONS on page 11.
To Next Page
Loading...