DETERMINING TREATMENT FREQUENCY AND DURATION
The length of your treatment time and the frequency of treatment will
depend on the intensity of pain you are treating:
PAIN LEVEL LIGHT PAIN AVERAGE PAIN SEVERE PAIN
Frequency
(How Often)
Once a day Twice a day Three times a day
Duration
(How Long)
10-minute
treatment time
15-minute
treatment time
20-minute
treatment time
NOTE: Do not use continuously for more than 30 minutes; wait at least
6 hours between treatment sessions.
Wellness Recovery Collection 15 14 AllevaBody User Manual Lifepro
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
TROUBLESHOOTING GUIDE
Quickly troubleshoot simple issues you might experience with the
AllevaBody using the table below.
Please contact a customer support representative for additional
assistance at: support@lifeprofitness.com or (800) 563-6604. Please
do not attempt to repair the device.
ISSUE POSSIBLE REASON HOW TO RESOLVE
DEVICE IS NOT
WORKING
Device is not plugged in.
Connect each remote control cable to
a mat. Connect a power supply to each
remote control cable. Plug a power cord
into each power supply and then into an
electrical outlet.
Device is not turned on.
The remote controls will turn on
automatically when connected to power.
Press the On/Off button to turn on each
mat and begin the treatment session.
DISPLAY ON
THE REMOTE
CONTROL IS ON,
BUT THE DEVICE
IS NOT WORKING
Device is in settings
mode.
Adjust the settings if desired, then
press the On/Off button on each remote
control to begin the treatment program.
DEVICE STOPPED
WORKING
SUDDENLY
Device automatically
shuts off after the set
working time.
Press the On/Off button on each remote
control to turn on and begin a new
session.
A mat, remote control,
power supply, or power
cable has become
disconnected.
Check all connections to ensure
everything is plugged in firmly and all
locking rings are tightened completely.
INTENSITY IS
TOO STRONG OR
TOO WEAK
The brightness level
(intensity) or pulse
frequency selected is
not optimal.
Choose a different brightness level
and/or pulse frequency using the
Settings button. We recommend starting
with the lowest levels.
SOME LED
LIGHTS DO NOT
APPEAR TO
BE ON WHILE
THE DEVICE IS
RUNNING
Near-infrared (NIR)
light is not visible to the
naked eye.
The device is working when the timer is
counting down. If the mode is set to NIR
or RED&NIR mode, some or all of the
LEDs may not appear to be on.
To Next Page
Loading...