8 RevitaGlow Pro User Manual Lifepro
Wellness Recovery Collection 9
Before your first treatment, it is important to perform a skin sensitivity
test to ensure you won’t experience any adverse reactions to light therapy.
To do a sensitivity test:
1. Plug the face mask into the remote control and place the mask on your
inner arm, with the LEDs against your skin.
2. Press and hold the On/Off button for three seconds to turn on the
RevitaGlow Pro. Press on On/Off button a second time to begin the
session. Allow the entire default 10-minute treatment program to run.
3. If your skin feels uncomfortable or hot at any point during the test
treatment, stop using the RevitaGlow Pro immediately.
4. Wait at least 6 hours after the sensitivity test. If your skin becomes red
and/or itchy, you may be sensitive to light therapy and you should not
continue to use the RevitaGlow Pro.
NOTE: Please see a list of contraindications (people who should not use
this device) on page 20.
TESTING FOR SKIN SENSITIVITY
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
NOTE: Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
PREPARING FOR YOUR TREATMENT SESSION
• Wash your face, neck, and upper chest.
• Carefully pat your skin dry with a soft towel.
• Apply a light, soothing moisturizer to your skin, if desired.
SETTING UP THE MASKS
• Locate the three pairs of Velcro
®
straps.
• Attach two pairs of straps to the face mask and one pair of
straps to the neck mask following the instructions on page 10.
• Plug the USB cable exiting the bottom of the face mask into one
of the standard USB ports at the top of the remote control.
• Plug the USB cable exiting the bottom of the neck mask into the
other standard USB port on the remote control.
BEGINNING YOUR TREATMENT SESSION
• Lie down on a flat comfortable surface, such as a bed or couch.
• Place the RevitaGlow Pro in position on your face, with the LED-
side against your skin.
• Fasten the Velcro
®
straps to secure the mask to your face
following the instructions on page 11.
• Lay the neck/chest mask on your upper chest and attach the
Velcro
®
straps to secure it around your neck following the
instructions on page 11.
• Press and hold the On/Off button on the remote control for
three seconds to turn on the RevitaGlow Pro.
• Adjust the time, color mode, and intensity as desired. See
OPERATING INSTRUCTIONS on the next pages for details.
• Press the On/Off button a second time to start the session.
2
3
1
EASYSTART SETUP GUIDE
To Next Page
Loading...
