52
NOTE: When lubricating the belt, make sure the treadmill is on a
surface that can be easily cleaned. After lubricating clean any excess
silicone o the walking surface of the belt and side rails.
Belt Lubrication
Use only 100% silicone and avoid using aerosol silicone sprays which include
additives and petroleum distillates. One ounce of silicone should be used for each
application. LifeSpan oers 100% silicone lubricant that can be ordered at www.
LifeSpanFitness.com.
The walking belt should be lubricated every 50 hours of use or three months.
To lubricate, unplug your treadmill.
1. Start toward the front of the treadmill, slide your hand under the belt and lift
it away from the deck.
2. Slide tube under the belt as close to the center as possible.
3. Apply controlled pressure to the squeeze bottle as you slowly pull back the
tube towards the belt edge.
4. Repeat on opposite side. (Use 1/2 oz. per side)
5. Use treadmill for 3-5 minutes to disperse lube.
For a full video
demonstration on
lubricating your
treadmill, scan the
QR code to watch our
YouTube video.
Maintenance and Tips
To Next Page
Loading...
