Lifetime 60058 - Page 27

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
27
SEC
ADW
ADW
SEC
2.14
Set two Latch Assemblies (BJA)JOUIFMPDBUJPOTTIPXOBOEBMJHOUIFIPMFTJOUIF-BUDIFTXJUIUIFEJWPUTJOUIF
1BOFM%SJMMPOFwIPMFJOUPUIFIPMFJOFBDI-BUDIBOEUISPVHIUIFQMBTUJD*OTFSUB#10 x 3/4” Phillips Pan-
Head Screw (ADW)JOUPUIFIPMFPGFBDI-BUDIVOUJMUIFIFBEPGUIF4DSFXJTnVTIXJUIUIF-BUDIIt’s OK if the Screws
(ADW) spin freely at this point. Do not worry about stripping the plastic. Finally, on the inside of the Tumbler, secure the
-BUDIFTXJUIUXPPlastic Nuts (BHK). Tighten the Screws (ADW) into the Plastic Nuts (BHK) with a screwdriver only. Do not
overtighten.
BHKY
ADWY
2
BJAY
BJA
BJA
ARAY