Lifetime 60058 - Page 29

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
29
SEC
SEC
2.16
SEC
2.17
Place two Hinge Tubes (BJB) onto the Lid (BHN)BUUIFMPDBUJPOTTIPXO%SJMMUXPwIPMFTJOUPUIFIPMFTJOFBDI
)JOHF5VCFBOEUISPVHIUIF-JE5IFOJOTFSUGPVS#10 x 3/4” Phillips Pan-Head Screws (ADW). It’s OK if the Screws
(ADW) spin freely at this point. Do not worry about stripping the plastic. Finally, place a Plastic Nut (BHK) over each Screw
BOEDPOUJOVFUJHIUFOJOHUIF4DSFXTCZIBOEVOUJMUIF1MBTUJD/VUTmUUJHIUBOEnVTIBHBJOTUUIF-JETighten the
Screws (ADW) into the Plastic Nuts (BHK) with a screwdriver only. Do not overtighten.
BHK
ADW
BHN
BJB
BJB
BIZ
BIZ
ADW
ADW
ADW
BHK
BHK
BHK
BHKY
ADWY
2
BIZY
BJBY
Place two Latch Hooks (BIZ)POUPUIFPQQPTJUFFOEPG-JEBUUIFMPDBUJPOTTIPXO%SJMMUXPwIPMFTJOUPUIF
IPMFTJOFBDI-BUDI)PPLBOEUISPVHIUIF-JE5IFOJOTFSUGPVS#10 x 3/4” Phillips Pan-Head Screws (ADW). It’s
OK if the Screws (ADW) spin freely at this point. Do not worry about stripping the plastic. Place a Plastic Nut (BHK) over each
4DSFXBOEDPOUJOVFUJHIUFOJOHUIF4DSFXTCZIBOEVOUJMUIF1MBTUJD/VUTmUUJHIUBOEnVTIBHBJOTUUIF-JE
Tighten the Screws (ADW) into the Plastic Nuts (BHK) with a screwdriver only. Do not overtighten. Set aside for later.
ARAY