Lifetime 90136 - Section 1.5: Attaching Bottom Tubes

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
15
Remove 5/16” Nylock Nut (ASE) from the bottom two Light Brown Tubes
(CPD)0LACEANEW,IGHT"ROWN4UBEATTHEBOTTOMOFTHEGREEN
PENTAGONASSEMBLIES3ECURETHE,IGHT"ROWN4UBEANDGreen
Tubes (CPC)TOTHEEXISTINGJOINTBYREPLACINGTHEWasher (ARL) and the
.YLOCK.UT4IGHTENCOMPLETELY
SEC
1.5
CPC
*OINT"
*OINT!
Note: Make sure all Bolts on the bottom go in the direction shown,
with the head of the Bolt on the outside, to prevent injury.
!
3/16”
1/2”
*OINT#
CPC
CPD
ARL
ARL
ARL
ARL
ARN
ARN
ASE
ASE
NO NEW HARDWARE REQUIRED
&/24()30!'%