Lifetime 90160 - Page 28

28
TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
1/2”
!!*X
ABDX
!"&X
!"&
!"&
!!*
ABG
ABD
!"&
!,8
Insert two 5/16” x 2 1/2” Tap Bolts (ABG) with the 5/16” Washers (ABD) and the
v2UBBER7ASHERS!"&THROUGHTHEBOTTOMHOLESINTHEBACKOFTHERim
!,8 as shown, and secure the hardware with two v(EX4.UTS!!*.
SEC
3.3
Note: Do not overtighten the hardware so that the 7/16” Rubber
Washers bulge outward as shown.
!
Note: Make sure that the 5/16” x 2 1/2” Tap Bolts are
positioned on the outside edge of the holes as shown.
!
Correct
Incorrect
ABG
ABG
!!*
!!*
!,8
ABGX