TOOLS AND HARDWARE REQUIRED FOR THIS PAGE
SEC
5.10
(OOKONEOFTHEENDSOFA3PRING!*9 into the #2 hole on the Left
"ACKBOARD"RACKET!** as shown.
SEC
5.11
Using the closed end of a Wrench, stretch the 3PRINGS!*9 up and over
the 3/8” x 7” Hex Bolt (AAZ) as shown.
Note: Make sure all hardware has been securely tightened before moving to the next section.
!
Wrench
./(!2$7!2%2%15)2%$&/24()30!'%
Note: Repeat this step to hook the end of the other Spring
into the #2 hole in the Right Backboard Bracket (AJK).
!
!*9
!**
2
!*9
AAZ
To Next Page
Loading...
