INSTRUCTIONS 34
DIRECTIONAL
CONNECT
DISCONNECT
TURN / FLIP NOTE ICON
POWER ON TEST
TWIST / BRAIDBEND / PIVOT
LEGO
®
CONCORDE 10318 LIGHT KIT INSTALL GUIDE
NOTE
Connect to a 5V USB Power
Bank, 5V USB Wall Adaptor, or
USB to AA Battery Pack (sold
separately)
If you experience any issues with the
lights not working and suspect an issue
with a component, please try a dierent
port on the expansion board to verify
where the fault lies (with the light or
expansion board). To correct any issues
with expansion board ports, please view
the section addressing expansion board
issues in our troubleshooting section.
!
!
NOTE
Raise the landing gear by
twisting the tail cone again.
NOTE
You should have these parts
left over that were removed
from the LEGO set
Removed Pieces
To Next Page
Loading...
