Light speaker E2 - Installation and Setup; Installation Considerations

To Next Page

To Previous Page

Tech Support: 1-800-268-1172

Installation Considerations

Your

e²

Wireless SubWoofer can be placed in any area or

zone where you would like additional bass to your existing

LightSpeaker

distributed audio system. The only wiring

required is to plug it into a standard electrical outlet.

This SubWoofer will perform perfectly adding rich, deep

bass from wherever it is placed in your room, however,

it will provide the most bass if it is placed in or close to a

room corner. Ideal positioning would be to place it in a

room corner and not further then 4 feet or not less than

7 feet from one of your LightSpeakers

or AudioRocks.

Distances between 4 and 7 feet may require the PHASE

switch to be changed from 0° to 180°. Please see Page

11 of the manual for instructions on how to do this. Your

e²

wireless SubWoofer will operate up to 50 feet (in any

direction) away from your LightSpeaker

transmitter.

Please take a few minutes to read this manual. Following

simple setup instructions, will ensure you get the most

from your LightSpeaker

SubWoofer.

e2 Sub Manual English.indd 8 10-07-28 11:36 AM