6
ENGLISH
Warning
- The smoke machine must be placed at least 100 cm away from inflammable materials such as
curtains, books, etc. Make sure that the housing cannot be touched by accident.
- For indoor use only.
- During installation, nobody should stand beneath the mounting area.
- Prior to the first use, have the unit checked by a qualified person.
- The unit contains voltage carrying parts. DO NOT open the smoke machine
- Never plug or unplug the unit with wet hands.
- If the plug and/or mains lead are damaged, they need to be repaired by a qualified technician.
- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a
mains outlet. It needs to be repaired by a qualified technician.
- Only connect this unit to an earthed mains outlet of 230Vac/50Hz .
- Always unplug the unit during a thunderstorm or when it is not in use.
- If the unit has not been used for a longer period of time, condensation can occur inside the hous-
ing. Please let the unit reach room temperature prior to use.
- When you unplug the unit from the mains always pull the plug, never the lead.
- In order to prevent dropping of the unit, a safety fastening needs to be installed. This can be a
solid chain, a steel cable, etc. which has to be fastened separately from the mounting bracket.
- The supplied bracket is the main fixing and must be used to solidly mount the light effect.
- In order to avoid accidents in public premises, the local legal requirements and safety regula-
tions/warnings must be fulfilled.
- Keep out of the reach of children.
Installation and Use
Unpack the fog machine. Do not connect yet the net cable. Connect the lead of the manual control
with the 3-pin plug at the rear of the smoke machine. Fill the fluid tank by means of a funnel.
Connect the remote control with the Remote Control-socket. Plug the unit into a mains outlet. The
heating element is automatically switched
on. Depending on the room temperature, it takes about 8 minutes until the working temperature
is reached, during this time the display shows “Warming Up”. When the machine is ready for fog-
ging, the display shows "Ready To Fog".
To Next Page
Loading...
