Lightolier LYTEJACKS FIXTURES User Manual

F
INSTRUCTION SHEET NO.
INSTRUCTIONS FOR CONNECTING LYTEJACKS FIXTURES
TO 8600 SYSTEM POWER JACKS.
IS:8672
0989 Pagel of2
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE.
This fixture is intended for installation in accordance with the National Electrical Code and local
regulations. To assure full compliance with local codes and regulations, check with your local electrical
inspector before installation. To prevent electrical shock, turn off electricity at fuse box before
proceeding.
Retain these instructions for maintenance reference.
NOTE: Use this Focal Jack with a 50 watt Power Jack.
1. Turn power off. Insert the top of the STEM (Fig. 1) fully into the POWER JACK RECEPTACLE. Verify
engagement by exerting a LIGHT DOWNWARD pull. The STEM should not release from the POWER
JACK.
2. To remove the fixture, grasp the STEM and FIRMLY pull DOWNWARD until STEM is disengaged from
the SOCKET RECEPTACLE.
FIXTURES ARE DESIGNED FOR 360° HORIZONTAL ROTATION and 0° TO 90° VERTICAL ADJUSTMENT.
P
Q
TYPICAL POWER JACK
FIG. 1
SEE BACK FOR LAMPING
.

Lightolier LYTEJACKS FIXTURES Specifications

General

Brand	Lightolier
Model	LYTEJACKS FIXTURES
Category	Indoor Furnishing
Language	English

Summary

Instructions for Connecting Lytejacks Fixtures to 8600 System Power Jacks

Installation Procedure

Step-by-step guide for inserting and securing the fixture STEM into the POWER JACK RECEPTACLE and its removal.

Fixture Design Features

Describes the fixture's capabilities for horizontal rotation and vertical adjustment.

Instructions for Lamping

Lamping Procedure

Steps for removing the aperture baffle, assembling the lamp with glass guard, and connecting the socket.

Important Warnings and Notes

Crucial safety advice regarding lamp guard placement, cooling, dimming compatibility, and maximum wattage.