10
Bluetooth and Cell Phones
Connecting Bluetooth Cell Phones for the
First Time
Before using a Bluetooth cell phone for the
rst time with Sierra it must be “paired” or
electronically connected.
To pair a Bluetooth cell phone with Sierra:
1. Turn on the headset and verify the green
LED is ashing. Make sure Sierra’s Bluetooth
mode is turned o. Blue or red ashes from
the Bluetooth LED should not be present (see
“Bluetooth Mode—ON and OFF”, page 11).
2. Press and hold the Sierra Bluetooth button
for about ve to ten seconds or until the
Bluetooth LED continually ashes red and
blue. This indicates the Sierra pairing mode
setting and lasts about two minutes. If this
step takes longer and the Bluetooth LED is
no longer alternating red and blue, start over
from step one.
3. With Sierra in pairing mode, follow the menu
prompts on your Bluetooth phone directing
it to look for Bluetooth devices.
4. Select Lightspeed-V### (numbers may vary)
on your Bluetooth phone from the list of
found devices
5. If asked to enter a password or PIN, enter 0000
Your cell phone should now be paired and ready
for continued use with Sierra.
To Next Page
Loading...